DME-II_Thermal Engineering-II_Boiler-II

-

Classification of Boiler:


Difference Between Fire Tube and Water Tube Boiler:


Comments

Post a Comment

Popular posts from this blog

DME-III_Design of Machine Elements_Design of Levers

-
Image
Design of Levers: Hand Lever, Foot Lever, Bell crank lever Design of levers  Key points to remember regarding design of levers: the design of levers is all about finding the dimensions of the levers so that it could perform its function satisfactorily A lever is force multiplier, depending upon the location of the load and effort from the fulcrum point. Levers are classified on the basis of location of load, effort and fulcrum point. Levers are found in numerous machines and devices serving different purposes, mainly force transmission with multiplications. Levers make our day to day life easier, they make ease in lifting, ease in cutting, ease in holding, ease in opening tight things. Hammer claws, wheel barrows, pickup tonges, Scicors, bottle openers etc. are the examples of day to day use of levers. A lever is meant to make the work easy, so it actually reduces the effort required to do a work. The effort ...
Read more

DME_Design of Machine Elements_Keys and Couplings

-
Image
Keys A key can be defined as a machine element which is used to connect the transmission shaft to rotating machine elements like pulleys, gears, sprockets or flywheels. A keyed joint consisting of shaft, hub and key.    There are two basic functions of the key. i)                  The primary function of the key is to transmit the torque from the shaft to the hub of the mating element and vice versa. ii)                 The second function of the key is to prevent relative rotational motion between the shaft and the joined machine element like gear or pulley. In most of the cases, the key also prevents axial motion between two elements, except in case of feather key or splined connection. There are different ways to classify key the keys. Some of them are as follow: ·       ...
Read more

DME-III_Design of Machine Elements_Cotter Joint Numerical Problem

-
Image
Design procedure of cotter joint in tabular form  Numerical Problems 1) Design and draw a detailed sketch of cotter joint which is required to withstand a load of 30 kN in tension and compression. The material used for the cotter joint has following allowable stress values Allowable stress in tension =50 MPa, Shear Stress =35 Mpa Crushing stress= 90 Mpa 2) Design and draw cotter joint required to withstand a load of 45 kN, The cotter joint is made up of material having following allowable stresses Allowable stress in tension =55 MPa Allowable shear stress = 40 MPa Allowable Crushing stress = 70 MPa 3) It is required to design a cotter joint which is used to connect two steel rods having same diameter. The maximum axial load on the joint is 50 kN. The material used for joint is 30C8 ,ultimate tensile stress for the material is 400 MPa. Using factor of safety 6. Design all dimensions of the joint. Take ultimate shear stress half th...
Read more